Loading...

Mr. SHOT® Prime Installation (Difference between Prime & Regular Model)

Mr. SHOT® Prime Instant Running Water Heater Made of First Class ABS Plastic / With On Off Switch / Manual Reset Model

Mr. SHOT Instant water heater Now comes with unbreakable First Class ABS(Acrylonitrile butadiene styrene) body and water inlet and outlet Thread type. It is more convenient for usage and it will avoid water leakages. Our geyser is portable, Instant, Compact, Less power consumption and affordable price. (Up to 20% saves electricity compare to other storage geysers*) Auto Cut off feature also available when the users forget to switch off it will go to automatically cut it off.

Drain the Water Heater

Connect a garden hose to the hose bib near the bottom of the water heater and extend the hose to a floor drain or outside location.

Turn off the power to the water heater or set the gas control valve to the “Vacation” setting. Close the cold water inlet valve which is usually located at the top of the tank. Open the drain valve and turn on the closest hot water faucet to allow air into the tank.

Allow the tank to empty fully before proceeding. Obviously, larger hot water heater sizes will take a bit longer to drain but it shouldn’t take more than a few minutes.

Remove the garden hose from the drain valve. If your water heater has a plastic drain valve, this is a good time to replace it with a more durable brass valve. Using a large adjustable wrench, remove the drain valve and replace with the brass valve.

Cleaning and Flushing the Tank

Your local hardware store will sell a long, narrow brush that is designed for refrigerator coils but is also excellent for water heater tank cleaning.

Insert the brush into the opening where the drain valve was removed. Carefully use the brush to scrape the bottom of the tank and as much of the interior sides of the tank as you can reach.

If your tank has not been cleaned in a while, this can take a bit of time. The more of the sediments you can break loose, the better your water heater will function.

Screw a short 3/4 inch plumbing nipple into the drain opening. Drain valves are not suitable for tank cleaning because they are easily clogged by the debris that will be flushed out.

Place a bucket directly below the plumbing nipple or connect a garden hose to the other end of the nipple (or let it drain into a properly installed drain pan). Insert the other end of the hose (if using one) into a bucket so you will be able to see the results of your cleaning.

Turn on the cold water inlet valve and allow it to run until the water coming out of the hose clear. Remove the nipple and repeat the process until no more sediments are washed out after scrubbing. There may be rust, calcium deposits or other debris in the bucket.

Note:  Many newer water heaters include “self-cleaning” feature. While helpful, you still want to manually flush and clean a water heater but you simply don’t have to do so as often. So instead of an annual cleaning, doing so every 3 years or so should suffice.

Completing the Project

Turn off the hot water faucet. Instead of replacing the drain valve, you can install an inline ball valve on the end of the nipple to make future cleaning easier. You will need to add a second, short nipple to the outlet side of the valve.

Wrap the threads on both ends of the nipple with plumber’s tape and tighten the nipple securely into the tank. Screw on the ball valve and tighten it properly

One Reply to “Mr. SHOT® Prime Installation (Difference between Prime & Regular Model)”

  1. Anu

    Reply

    Dear Sir,

    Have procured this product on 22nd Dec, now it’s malfunctioning. Can you send technician to rectify this issue.

    For more clarification please feel free to contact 9600648809.

    Regards,
    Anu.

Leave a Reply

Your email address will not be published. Required fields are marked *